Currency

+48 889 683 903 0

STD or oversize? How to choose piston and ring size

Pistons, piston rings and bearings are sold in a standard size (STD) and in graded sizes. Which one you need depends on the condition of the cylinder bores and the crankshaft journals, not on the engine model alone.

What STD, oversize and undersize mean

  • STD (standard size) is the size the engine had when it left the factory.
  • Oversize (for example +0.25, +0.50, +0.75 or +1.00 mm) applies to pistons and piston rings. After the cylinders have worn, the block or liners are honed or bored to a slightly larger diameter, and pistons and rings in the matching oversize are fitted. Not every engine is offered in every step.
  • Undersize (for example 0.25 or 0.50 mm) applies to bearings. When the crankshaft journals are ground smaller, bearings that are thinner by the same amount are fitted.

How to decide

  1. Measure the cylinder bores in several places with a bore gauge and compare the result with the wear limit in the service manual of your engine.
  2. If the bores are within the limit, standard size (STD) pistons and rings are used.
  3. If they are worn beyond the limit, the machine shop re-bores or hones the cylinders to the next oversize. Order pistons and rings only after the machine shop has confirmed the final size.
  4. For the crankshaft, measure the journals. If they are ground, order bearings for the size the machine shop gives you.

Common mistakes

  • Ordering an oversize before the bores have been measured.
  • Mixing sizes between cylinders without the machine shop’s confirmation.
  • Forgetting that rings must match the piston size, too.
  • Trusting the marking on the old piston: it may show the size from a previous overhaul.

How sizes are shown in our shop

Where a part comes in several sizes, the choice is shown as STD (standard size) and, for example, +0.50 mm (oversize) on pistons and rings, or 0.50 mm (undersize) on bearings. See the lists of pistons, piston rings and main bearings. If you are unsure, send us the engine model and the measured size through the contact form and we will help you check the part.

Always follow the service manual of your engine for the wear limits and fitting clearances.

Cookie settings